|
|
You are here: Knowledge Base > Installation Instructions
|
Bradley WS-2WMD Dual Station Wall saver Shower (Multi Stall ) Stainless Steel,Bradley WS-3WMT Three Station Wall Saver Shower installation instructi Last Updated: 03/24/2008 |
||
|
Installation Instructions Step 1: Install shower NOTE: Flush supply lines before making connections. 1. Rough-in supply piping to your shower as shown in Figure 1. NOTE: Use the cold inlet location for tempered supply. 2. At dimensions shown in Figure 1, mark two wall bracket anchor locations using wall bracket as a template. 3. Install wall anchors for 1/4" diameter screws at marked locations (anchors and screws supplied by installer). 4. Secure two wall brackets to wall anchors with 1/4" diameter screws (supplied by installer) (see Figure 1). 5. Hang back of shower onto two wall brackets installed in Step 1. 6. Secure bracket on bottom cover of shower to wall with 1/4" anchors and screws (supplied by installer). 7. Remove eight #10-24 x 1/2" button head screws which secure the top cover to the showershell and lift top cover off. 8. Connect water supply to copper tubes inside shower body. NOTE: Supplies can be brought in from back of shower or through knockouts located on top shower. 9. Turn on water to your shower and check for leaks. 10. Refasten top cover to showershell with eight #10-24 x 1/2" button head screws. Vertical Shroud Installation (Optional) 1. Position wall bracket on top of shower as shown in Figure 2 and secure with 1/4" diameter screws (supplied by installer). 2. Position slip ring against ceiling and in line with bracket installed in Step 1 (see Figure 2). 3. With bracket and slip ring secured, position shroud in place and secure shroud to lower bracket with screws provided (see Figure 2). 4. Using holes at top of shroud as a template, drill and tap #10-24 holes in slip ring. 5. Secure shroud to slip ring with #10-24 screws provided (see Figure 2). Horizontal Shroud Installation (Optional) 1. Position bracket and slip ring in place on wall where desired and secure to wall with 1/4" diameter screws (supplied by installer) (see Figure 3). 2. Position shroud in place over the bracket and secure shroud to bracket with #10-24 x 1/2" screws provided (see Figure 3). 3. Using shroud as a template, drill and tap #10-24 holes (use 5/32 drill) in slip ring. Secure shroud to slip ring with #10-24 x 1/2" screws provided (see Figure 3). NOTE: Shroud mounting holes may be punched in front face of shroud.
|